FAQ
Frequently asked questions
Can’t find your answer? Write to us.
Will it work on any boat?
It works on every boat without wood in the hull layers: fiberglass, aluminum, steel and composite.
Will it remove existing fouling?
No. Hull Shield is preventive. Clean the hull fully before installation; small barnacles can survive up to a month out of the water.
Does it need to be on all the time?
Yes. Protection depends on continuous operation, and the current draw is very low.
Will it drain my battery?
No. It monitors battery voltage and switches to a no-drain sleep mode below 50% capacity.
Do I need shore power?
No. It runs on batteries kept up by a standard charger, solar or wind. Solar must sustain a continuous 1–2 Ah draw when not charging.
Do I need to drill holes?
No. Transducers are bonded inside the hull. On cored hulls the foam layer may need removing at the mounting point.
Will it cause electrolysis?
No. Transducers are isolated from the rest of the boat and run on AC.
Is it noisy, or harmful to my boat?
No. Ultrasound is above human hearing and safe for the structure. Right next to a transducer you may hear a faint click at frequency changes.
Do I still need bottom paint?
It depends. You’ll need the least maintenance with a soft ablative paint.
Is it harmful to marine life?
No. Ultrasound is absorbed at the hull surface and doesn’t affect anything not in contact with the hull.


